There are 10 active users currently online

Starfleet Excelsior Class Heavy Cruiser

Starfleet Excelsior Class Heavy Cruiser

Illustrator: Eric Kristiansen
Copyright: 1994


1. These plans are for the familiarization purposes only and should not be confused with detailed working drawings of the Excelsior Class Heavy Cruiser.

2. In an emergency, the primary hull can separate from the secondary hull. The secondary hull cannot operate independently.

3. The auxiliary fusion reactors can provide life-support and sublight propulsion in the event of a hull separation. Normally they provide supplementary power.

4. Hydrogen and other interstellar gases are collected and processed for use as fuel in the auxiliary power systems and impulse engines.

5. Except when berthed, the craft is crewed at all times. The ship's compliment is divided into four watches of six hours.

6. All decks have built in gravity, inertial dampening and anti-radiation force fields.

7. Environmental suits are fully adjustable and stored in various strategic locations throughout the vessel.

8. The Excelsior class can accept multiple hull violations. All doors and bulkheads are airtight and capable of withstanding sudden drastic pressure changes. The containment doors seal off sections of the ship to prevent progressive decompression. They are kept open during normal operations, but will close when all stations have been secured or when the hull has been breached. Doors adjacent to evacuated sections can only be overridden by damage control parties. There are similar containment hatches which can seal off all gangways.

9. AUTHOR'S NOTE: The original Cross Section (located at the rear of the bridge on 1701B) is dramatically incorrect, based on the craft's established length of 467m, a height of 74.93m was calculated. The original cross section shows 36 decks which works out to 2.08m per deck which is just over 6 feet tall (the average ceiling space is 8 feet). 2.08 meters would not leave enough clearance for flooring, conduit, ceiling material and structural support. I have based my design on a more accepted deck height of 2.75m which works out to 9 feet (8 feet for the ceiling and a foot for everything else). I have tried to match the location of various components from the original design when sensible. Some items have been moved to more logical locations. The navigational deflector should have been drawn penetrating the additional cowling and the intermix chamber does not line up with the deflection crystals. Also, the original forward torpedo bay would have fired straight into the navigation dome. But as always, feel free to believe the original layout is correct and disregard the new cross section.

Purchase a set of these Data Sheets by clicking the banner / link below.

Jackill Data Sheets

Only one full-sized sample image is available. Please support the illustrator and [purchase] these great data sheets

Starfleet Excelsior Class Heavy Cruiser Blueprints
Starfleet Excelsior Class Heavy Cruiser Blueprints
|Sheet 1: Port and Cut-Away Views / Ship Silhouettes|
|Sheet 2: Dorsal / Fore Views|
Starfleet Excelsior Class Heavy Cruiser Blueprints
|Sheet 3: Ventral / Aft Views|

Follow Cygnus-X1.Net!
Cygnus-X1.Net on Facebook  Cygnus-X1.Net Twitter Feed
Help Support Cygnus-X1.Net!

Donations are used to offset the cost of running and maintaining this site.
A single dollar goes a long way :-)
Thank you!

Cygnus-X1.Net: A Tribute to Star Trek